Standing Seam Metal Roof Flashing Details

Endwall details for standing seam endwall option 1 using counter flashing panel goes down first then the z channel and then the endwall flashing then the counter flashing and finally the tube sealant.

Standing seam metal roof flashing details. Clipless one piece positive locking standing seam panel that provides a timeless roof appearance. Panels are mechanically attached with hidden fasteners to a continuous solid substrate with an underlayment. Deck w iso details. Rake to metal wall detail.

For longer slopes and lower roof pitches contact fabral for other suitable profiles. Standing seam metal roofing is a concealed fastener roofing system which features vertical or trapezoidal legs with a flat space in between. The most common flashing for standing seam roofing is the ridge cap which is used at the peak of a roof where two opposing roof slopes join and attaches to the roof with z flashing. This detail shows a method of detailing a valley condition on a standing seam roof.

The continuous locking strip is soldered to the valley flashing. These options can be ordered in various finishes materials and over 30 kynar 500 hylar 5000 colors. Standing seam consists of sheet metal roofing panels joined side by side and attached to the roofing deck with concealed fasteners. Roof pitch the metal roofing panels shown in this manual require a min imum slope of 2 ʺ per foot to ensure proper drainage.

The copper roofing laps the valley flashing a minimum of 6 and is folded and locked into a continuous copper locking strip. Ndl flashing inclusive 20 year warranty. Refer to the rain carrying table in this booklet for the maximum allowable panel length per slope that will provide adequate drainage. The standing seam metal roofing systems from berridge include a wide range of coverage and seam height options.

Browse our available standing seam metal roofing or contact a representative today for more information. Pac 150 90 single lock. Applicability the metal roof system as described within this manual is classified as a standing seam metal roof panel. The connecting point where the two separate metal panels meet forms a vertically pointed rib or a seam that is one inch to inch and a half high.